How To Test Ge Washer Control Board
How To Test Ge Washer Control Board. Be sure that you are firmly pressing down on those buttons. Purchase a ge appliance part online learn how to replace the main control board on your washer:
We recommend that you have a service technician test the washing machine control board and user interface board or the washer timer before replacing control components. If i put the washing machine into test mode and move it to a wash test, it will fill with water and hold the water if i press the stop button. About press copyright contact us creators advertise developers terms privacy policy & safety how.
Insert A Putty Knife Between The Front Cabinet And Top Of The Washing Machine, Approximately 6 Inches From Each Side To Release The Spring Clips.
About press copyright contact us creators advertise developers terms privacy policy & safety how. Mostly the door latch is caused for ge frontload washer pausing during a cycle. To test this, place the washer in the service mode and run one of the following test modes t10, t11 or t14 (it doesn’t matter which one).
How Do You Manually Unlock A Ge Front Load Washer?
This switch allows the washing machine's control board to detect whether the lid is open or closed. Testing the controls typically requires live voltage checks. For models with an electronic control knob or electronic control panel, the wash cycle will need to be selected again and started after you restore power.
Why Does My Ge Washer Keep Pausing?
Ge front load washer can not get door lock to lock.installed new ge door lock no results. Indicates one or more key switch lines are stuck or shorted on either the control or the keypad. If i put the washing machine into test mode and move it to a wash test, it will fill with water and hold the water if i press the stop button.
For Many Top Load Washers, The Main Control Board Can Be Replaced Without Requiring Service.
Install new control board thinking that was the problem.can not turn off the control board. The washer door will lock, and the control panel will display t01 when it has successfully entered test mode. Be sure that you are firmly pressing down on those buttons.
The Switch Is Compressed By The Lid When The Lid Is Closed And Decompresses When The Lid Is Open.
Ran electrical tests listed it threads. If the control will not enter that test, you can try to enter the field service test shown below. If the motor isn’t the problem then the inverter or the control board is the problem.
Post a Comment for "How To Test Ge Washer Control Board"