Acutron 2 Control Board
Acutron 2 Control Board. Remove the 6 x 1/4” hex screws from the slotted back access panel 3. Acutron control board iv :
Unscrew the control board from the side of the heater (2 x 1/4” hex screws) 4. Learn how to tackle some common issues in your pelpro pellet stove. Replacement door gasket 3/4 x 60, fits pel pro pellet stoves that use the acutron control board.
Dansons Pellet Stove, Model Hhfp2Bd With A Acutron Ii Control Board.
Unscrew the control board from the side of the heater (2 x 1/4” hex screws) 4. Acutron control board iv : It starts up but will not cycle past #1 solid feed rate and the ignitor light stays on long after the fire is burning.
It Is A Direct Replacement Pcb Control With Updated Graphics And Mounting Brackets.
Remove the 6 x 1/4” hex screws from the slotted back access panel. Eventually the ignitor light goes out and. Using your pelpro stove for the first time operating your pelpro stove fuel & fuel storage for your pelpro stove how to find your pelpro stove model and serial number cleaning schedule for your pelpro stove how to clean your pelpro stove combustion fan how to clean your pelpro stove convection fan venting maintenance for your pelpro stove how to replace your.
Home Home No Yes Did Power Come On?
Always disconnect power to the appliance beforeperforming any service work 1‐877‐303‐3134 for customer service www.dansons.com step 5: Dansons group acutron control board installation (2 pages) pages: Unplug the stove’s power cord from the wall outlet.
Replacement Door Gasket 3/4 X 60, Fits Pel Pro Pellet Stoves That Use The Acutron Control Board.
Connect the 9 pin molex connector to the control board. Unplug the 9 pin wire harness from the back of the board 5. Wire harness acutron ctrl :
Add To Cart $34.99 Sku.
Free shipping for many products! Unscrew the control board from the side of the heater (2 x 1/4” hex screws) 4. Unscrew the control board from the side of the heater (2 x 1/4” hex screws) 4.
Post a Comment for "Acutron 2 Control Board"