Remove Bosch Dishwasher Control Board

Remove Bosch Dishwasher Control Board. The timer on the bosch dishwasher can be a replacement part that must be replaced if the bosch dishwasher does not start. This is a bosch dishwasher control board.

Bosch SHU43 Dishwasher Repair Dishwasher keeps running from zo-d.com

Remove the bosch dishwasher from its base and lay it so that all sides are accessible. Unplug the dishwasher and shut off the water supply before installing this part. Now that the control panel is out of the way, you can see things more clearly.

Source: www.applianceblog.com

Press “start/resume,” and also close the door within 3 secs. Check the bosch dishwasher’s timer.

Source: www.youtube.com

Push these in with a flat head screwdriver so that you can remove the control board. Close the door and allow the dishwasher to complete its cycle, which is usually a minute or less.

Source: zo-d.com

Disconnect the dishwasher from the electrical supply (unplug the dishwasher). Remove the panel, and then the control board with the wires will be visible.

Source: www.youtube.com

It is straightforward to remove the filter that is positioned at the bottom of the dishwasher. Two plastic base tabs hold the power module in place.

Source: zo-d.com

When the display shows 0:00, then the dishwasher is reset. Clean the drain hose using a rope brush.

Source: www.applianceblog.com

There are 2 screws coming in from the side of the control panel that you need to remove as well. The hose 00751456 carries water from the water inlet valve to the tub inlet.

Genuine Product Manufactured By Bosch.

You can now either replace just the control board or the power module. Two plastic base tabs hold the power module in place. To remove power module, gently pry base tabs until they clear module and lift the module up from the base.

To Locate The Board, Consult The Manual.

How do you take the front off a bosch dishwasher? Just remove the screws from the top of the door not forgetting the 2 screws that are on the side, gently wiggle and pull the control panel up exposing the 2 screws that are on the front. Remove them and the fascia panel comes right off.

Unplug Power Supply Cord From Rear Of Power Module.

The control board is like the computer that runs the dishwasher and if it is failing, problems are likely to occur. Close the door and wait approximately one minute. Clean the drain hose using a rope brush.

Push These In With A Flat Head Screwdriver So That You Can Remove The Control Board.

I have a bosch dishwasher sgv59t03gb/21 in which i just repaired a leak (caused by my own stupidity!) but it will not start up properly to allow me to check. The hose 00751456 carries water from the water inlet valve to the tub inlet. There are 2 screws coming in from the side of the control panel that you need to remove as well.

Dishwashers Have Power Modules At The Base On The Right Side, Not Behind Fascia Panels.

Wear work gloves to protect your hands. The dishwasher's control board ensures that the various cycles and settings can be properly managed, such as the washing and draining cycles. Disconnect the dishwasher and appliance entirely.