Caldera Spa Control Panel Instructions

Caldera Spa Control Panel Instructions. A licensed electrician must install the subpanel (available from your dealer) to supply power to the spa. Remove the power cord wires, and the power jumper wire (from line 2 and neutral) on the line side of the terminal block.

CALDERA SPA TOPSIDE CONTROL PANEL ADVENT EAGLE UTOPIA from www.thespaworks.com

Caldera spas utopia 2002 to 2009 /paradise topside 2002 to. This control box must be programed with the correct software code for your spa via a portable usb drive ( not included ). This owner’s manual will acquaint you with the operation and general maintenance of your new spa.

Source: www.boospa.net

Locate the main drain valve (bottom front) for the spa. Trade in your spa review your spa.

Source: thespaworks.com

Light adapter cedric to hawk box #76860. Standard mode (st) the spa water heats to the temperature as set at the bather’s panel.

Source: calderaspasparts.com

Snap bromine cartridge in at bottom of holder and mineral cartridge on top. Make sure the water line is at least six inches, the bottom of the control panel.

Source: www.thespaworks.com

Below are the correct replacement parts. All spa replacement parts, accessories and spa supplies sold on this website.

Source: www.thespaworks.com

Software jumpers will need to be configured via the control panel. Make sure the water line is at least six inches, the bottom of the control panel.

Source: www.thespaworks.com

We stock every caldera spa control panel that is still available. Caldera spas control panel, advent eagle, part # 76846.

Kit,Cnt Hd Cal 11C 2P Air 09.

For advent eagle control box, see; From the documentation, it looks like it is a 2005 hot tub. All spa replacement parts, accessories and spa supplies sold on this website.

Used On Many Highland And Vacanza Spas.

We realize you may see conflicting information, especially if you are getting tips and advice from the internet. Caldera spas advent eagle related specs: The spa works has a complete selection of caldera spa topside control panels.

Caldera Spas Control Panel, Advent Eagle, Part # 76846.

Disconnect the control panel's modular connector/ribbon cable in the control box. Turn the power off to the spa. This item is no longer available with no replacement.

This Item Has Been Discontinued By The Manufacturer.

All utopia models 3p5000 ‐ current. The overlay sticker you will receive for this topside control is generic and will not say caldera as shown in the picture. Control box removal and installation:

We Make It Easy To Access The Owner’s Manuals For Your Caldera Spas Hot Tub.

Remove the power cord wires, and the power jumper wire (from line 2 and neutral) on the line side of the terminal block. This control box must be programed with the correct software code for your spa via a portable usb drive ( not included ). Contact us if software update is needed.