Caldera Spa Control Panel Not Working

Caldera Spa Control Panel Not Working. Caldera spa aquatic melodies series auxiliary control panel #74381. For models aventine, marino, palatino, tarino, vanto 3rd quarter 2012 thru 2014 for use with the hawk control system.

CALDERA SPA VACANZA SERIES 5BUTTON TOPSIDE CONTROL PANEL from www.thespaworks.com

This topside looks the same as the older one used from 2006 thru 2009 on spa models the plug is not the same. This is the trouble shooting guide from caldera spas. Try jumping out the switch, remove the two wires from switch and use a small wire to jump across the two wires to make the board think the switch closes then see if the spa operates normally.

Source: www.ebay.co.uk

Now, unplug the topside from the circuit board. Reset the breaker by turning it off, then back on.

Source: www.walmart.com

Caldera spa control boards and panels, caldera spa topside and spa side controls, caldera spa filters, caldera spa heating elements, caldera spa led lights, caldera spa pumps, caldera spa pillows, and caldera spa sensors. If it is still not working, shut it off again, then disconnect the panel.

Source: calderaspasparts.com

Check for moisture under glass or on contacts; We stock every caldera spa control panel that is still available.

Source: www.thespaworks.com

Caldera spa advent eagle topside control panel. Hot tub spa supplies features a huge selection of hot tub parts for your caldera spa.

Source: www.thespaworks.com

See if the panel or any buttons are cracked or if it could have possibly gotten wet. If it is still not working, shut it off again, then disconnect the panel.

Source: www.thespaworks.com

If there is an aux. If problems persist, the control panel may need to be fully replaced, and it.

Inspect Circuit Board For Damage And Correct Power Output;

Now, unplug the topside from the circuit board. If all seems well then you may need to replace your control panel or consult your hot tub dealer. I have to turn off the breakers, turn them back on, and it all works fine again.

If This Occurs, Repeat The Gfci Test Procedure.

Free shipping in the continental usa. Resetting a hot tub control panel Everything is pointing towards the pressure switch according to caldera.

Turn On The Lower Amp Breaker First If You Have A Hot Tub Powered By 240 Volts.

This is the trouble shooting guide from caldera spas. If there is an aux. See if the circuit board is wet or damaged.

Try Jumping Out The Switch, Remove The Two Wires From Switch And Use A Small Wire To Jump Across The Two Wires To Make The Board Think The Switch Closes Then See If The Spa Operates Normally.

Caldera spa top side control panel #74904 no air blower. For models aventine, marino, palatino, tarino, vanto 3rd quarter 2012 thru 2014 for use with the hawk control system. If used as a retrofit replacement for the cedric control panel, you must also replace current control box with a hawk control box wat76856.

The Only Pump Working When This Is Present Is The Recirculation Pump.

Unplug the power cord or shut off both circuit breakers. Check that topside control number works with spa control chip version; This topside will not work on model years below.