How To Test Dryer Control Board
How To Test Dryer Control Board. The function of the component is to keep the inside of the dryer from getting too hot. How can i test or check the electronic boards for defects?
This gives an overall check of the control board electronics and. This could signal the control board that the clothes are dry. First of all, make sure the dryer is connected to a power source.
It Comes Back At 1.5 Ohms;
One way to narrow down the search for the problem is through process of elimination. If your dryer will not start, then replacing this control board could solve the problem. Just reinstall your board, and you’re back in business!
This Is A New Main Control Board Replacement Part For Dryers, Whirlpool Dryer Electronic Control Board Wpw10111606.
Test the plug to ensure that it is secure in the outlet. Enough research on the internet convinced me that the problem was the control board, so i came to appliancepartspros.com and used the parts finder to locate the correct replacement control board for my model. The function of the component is to keep the inside of the dryer from getting too hot.
I Tested The Startup Winding Motor:
This could signal the control board that the clothes are dry. It is possible to determine if the control board is an issue by entering the whirlpool duet dryer diagnostics. By doing all my troubleshooting from the main computer board and identifying the bad part, i can then check my inventory to see if i have the part on hand at the service call.
Put Your Multimeter Into The Set State Of The Switch And Insert The Probes Into The Terminals.
This board can also be in kenmore and maytag dryers. Connect your dryer to the wall outlet (or plug it in directly) and remove the control console panel. A control thermistor is included in the manufacturing of dryer appliances as a safety feature.
On Top Of That, Before Replacing The Unit’s Main Control Board, We Recommend Testing And Checking All Other Parts Of The Appliance First.
The dryer will start flashing and beeping without anyone touching the keypad. Indicates one or more key switch lines are stuck or shorted on either the control or the keypad. The problem is likely caused by the motor or the motor relay on the control board.
Post a Comment for "How To Test Dryer Control Board"